24v Driven Rollers

NDW's Strong Brushless Conveyor Rollers 50DRX and 60DRX have the ability to move light to semi-heavy loads upto 300 kg (with a single roller).  Our Driven Rollers are available with a range of mechanical configurations including material spec, transmission spec etc.

NDW'S 24V Driven Motor Roller is available in 50 and 60 dia and with the following Transmission Specifications (custom specs available on request).
​

Type 87 HTD-8M Timing Belt (Steel)

Type 86 HTD-8M Timing Belt (Plastic)

Type 80, 81 & 82 Round Belt Transmission

Type 89 Poly V Steel

Type 89 Poly V Plastic

Accumulating load roller with a steel HTD-8M pulley for a tangential toothed belt, fitted with two grooved ball bearings. Because it uses a friction coupling, this version is suitable for an accumulating roller conveyor for low-noise transportation of medium-heavy products with a hard and flat underside.

Accumulating load roller with a steel HTD-8M pulley for a tangential toothed belt, fitted with two grooved ball bearings. Because it uses a friction coupling, this version is suitable for an accumulating roller conveyor for low-noise transportation of medium-heavy products with a hard and flat underside.








​

Types 80 & 81 or types 80 & 82 together make up a round belt powered accumulating roller conveyor for the transportation of lightweight to medium-heavy products. This works as follows: a drive axle ø 25 or ø 35 mm is installed transversely beneath the rollers. Polyamide (PA 6) diabolo (deeply grooved) wheels with a sliding fitting have been threaded onto the axle. A round belt of no more than ø 6 mm is placed around the diabolo wheel and the groove in the roller. The pre-tensioned round belt provides friction between axle and diabolo wheel. This friction causes the roller to be driven. If the product on the roller is obstructed, then the diabolo wheel can slip on the axle. The advantage of this method of delivering power to the rollers is that it operates near enough silently, even at high speeds. You should take into account that the roller can acquire a static electric charge if non-conducting bearing cartridges are used, which can cause sparks to jump between the roller and the frame.








​

Fixed drive conveyor roller with a welded Steel Poly-VG head. Suitable for the transportation of medium-heavy products. This version is a low-noise conveyor-roller.








​

Fixed drive conveyor roller with a Poly-VG head , fitted with two grooved ball bearings. Suitable for the transportation of lightweight products. This version is exclusively for use in continuous transport and is a low-noise conveyor-roller.