PVC GLUED COVERING

PVC glued coverings

All PVC coverings are equipped with a cotton bottom layer, this layer will be glued to the surface of the tube.  These coatings are applied to drums, rollers, pulleys etc.  The main reasons for these coverings are to give more friction or to protect the surface of the tube.

General Characteristcs

• increases the friction between the conveyor belt and the drum
• reduces the chance for damage and wear on the conveyor belt and drum
• sound reductive
• smaller chance of stretch of the conveyor belt by less high band tension.

​Types

Friction smooth transparent (FGT)

• easy to clean

Friction smooth white (FGW)

• easy to clean
• widely used in the food industry

Friction sandblast transparent (FZsT)
​

Friction sandblast white (FGW)

• ​widely used in the food industry

Friction stud transparent (FNT)

• Studs 2.0mm dia x 1.0mm
• Is used for long conveyors in a dry environment

Friction stud white 

• easy to clean
• Is used for long conveyors in a dry environment, often used in the bakery industry 

Friction stud red (FNR)

• Studs 2.0mm dia x 1.0mm
• Less sensitive than the transparent and the white version
• A covering that is often used for powered drums or rollers for conveyors
• Thanks to the hard coating it can also be used for buffering

Friction checker white (FRW)

• Cross rib of 2.0mm high, Centre to Centre rid 7.0mm
• widely used in the food industry as a guide of conveyor belts.

Frictie Supper grip Grey (FSgG)

• supper grip's profile of 2.0mm thickness
  
• Very suitable covering on the top of V-belts, transmission belts and timing belts.  Also widely used on drive systems 

The stated information is a guideline that will apply under normal circumstances.  the information may be subject to change as a result of ongoing development.  We would advise you to contact is for further details.

RUBBER